How do the LED Indicators workUpdated a month ago
LED Indicators
During normal operation, your Moonwalkers may display any of the following LEDs.
Mode | Light Description |
|---|---|
| Startup | Moving White |
| Lock Mode | Solid White |
| Shift Mode (Full battery) | Solid Green |
| Shift Mode (< 50% battery) | Blinking Green |
| Safe Mode (Reduced Performance) 1 | Solid Yellow |
| Training Mode 2 | Solid Magenta |
| Battery Charging | Blinking Green |
| Battery Fully Charged | Solid Green |
| Error | Other blinking patterns (please see table below) |
1 Safe Mode (Reduced Performance)
2 Training Mode is available on ShiftOS 2.0 (version 20.1.0) and later.
Walking for an extended period can increase the internal temperature of the Moonwalkers above 122°F/50°C. When this happens, your speed will be reduced, and after some time, the shoes will stop with the status indicator lights flashing their respective code. Allow your Moonwalkers to cool, and you will be ready to walk again.
If there is an issue with your Moonwalkers, the LEDs will blink RED. Please see the below table:
Error Codes (software versions 19.0.2 and later)
Fault Description | # of fast blinks in RED |
|---|---|
Bad wireless connection | 1 |
Charging error | 2 |
Battery Low | 3 |
Battery temperature out of range | 4 |
Motor overcurrent | 5 |
Motor overvoltage | 6 |
Motor temperature out of range | 7 |
Bad motor hall sensors | 8 |
Bad brake resistor | 9 |
Bad electronics | 10 |
Bad motor controller | 11 |
Bad calibration | 12 |
| Others | 13 |
Error Codes (software versions earlier than version 19.0.2)
Fault Description | # of fast blinks in RED |
|---|---|
| Bad wireless connection | 1 |
| Charging error | 2 |
| Battery Low | 3 |
| Battery temperature out of range | 4 |
| Motor overcurrent | 5 |
| Motor overvoltage | 6 |
| Motor temperature out of range | 7 |
| Bad motor hall sensors | 8 |
| Bad brake resistor | 9 |
| Bad electronics | 10 |
| Bad controller | 11 |
| Others | 12 |